Before tapping a hole you need to drill it to the correct diameter. If the drill is too small the tap breaks; if it is too large the thread has no material and will not hold.
How to calculate the drill diameter
The practical rule for metric threads is: drill Ø = nominal thread Ø − pitch. For example, for M8 (pitch 1.25): 8 − 1.25 = 6.75, rounded to the standard 6.8 mm drill.
Metric coarse thread
| Thread | Pitch (mm) | Drill (mm) |
|---|---|---|
| M2 | 0.4 | 1.6 |
| M2.5 | 0.45 | 2.05 |
| M3 | 0.5 | 2.5 |
| M4 | 0.7 | 3.3 |
| M5 | 0.8 | 4.2 |
| M6 | 1 | 5 |
| M8 | 1.25 | 6.8 |
| M10 | 1.5 | 8.5 |
| M12 | 1.75 | 10.2 |
| M14 | 2 | 12 |
| M16 | 2 | 14 |
| M18 | 2.5 | 15.5 |
| M20 | 2.5 | 17.5 |
| M22 | 2.5 | 19.5 |
| M24 | 3 | 21 |
| M27 | 3 | 24 |
| M30 | 3.5 | 26.5 |
| M36 | 4 | 32 |
Metric fine thread
| Thread | Pitch (mm) | Drill (mm) |
|---|---|---|
| M8x1 | 1 | 7 |
| M10x1 | 1 | 9 |
| M10x1.25 | 1.25 | 8.8 |
| M12x1 | 1 | 11 |
| M12x1.25 | 1.25 | 10.8 |
| M12x1.5 | 1.5 | 10.5 |
| M14x1.5 | 1.5 | 12.5 |
| M16x1.5 | 1.5 | 14.5 |
| M18x1.5 | 1.5 | 16.5 |
| M20x1.5 | 1.5 | 18.5 |
| M22x1.5 | 1.5 | 20.5 |
| M24x1.5 | 1.5 | 22.5 |
| M24x2 | 2 | 22 |
| M27x2 | 2 | 25 |
| M30x1.5 | 1.5 | 28.5 |
| M30x2 | 2 | 28 |
Tips
- For blind holes, drill deeper than the thread: the tap needs free space at the bottom for chips.
- Use cutting oil or lubricant; in stainless steel also use low speed and constant feed.
- Values are the usual ones for 6H tolerance in steel and cast iron. In very soft or hard materials they may vary slightly.
Taps and drills for this chart
See our HSS-E TiN machine taps and ground HSS-E Co5 twist drills.